How do I adjust my waterjet to use BARTON abrasives?
Any changes of waterjet grades or abrasives from different suppliers will require recalibration of the abrasive flow rate. Because particle size distributions (PSD) vary from supplier-to-supplier abrasive will flow at different rates. Once the abrasive flow rate has been calculated, the measured feed rate Read more
How do I minimize the kerf loss?
The primary factors on kerf loss are nozzle diameter and orifice selection. Using a larger nozzle than needed will increase kerf loss. Orifice alignment will also affect kerf loss. Improper orifice alignment will cause the stream to bounce inside the nozzle and will decrease nozzle life and Read more
Does BARTON offer a garnet recycling program?
Yes. BARTON offers a garnet recycling program to a limited number of customers. Local and regional restrictions limit the areas the program is available. Contact your regional sales manager to learn more.
HPX is often the higher priced waterjet abrasive. Why would I choose HPX garnet?
HPX is a hard rock garnet abrasive with an Adirondack advantage — the sharpest, hardest garnet crystals on Earth with a unique crystalline structure and durability. Named for the Adirondack Mountains where it is exclusively mined by BARTON, ADIRONDACK HPX Read more
Can garnet be used to etch with a waterjet?
BARTON garnet abrasives can be used to etch using a waterjet. However not all waterjet equipment has the software required for etching. Check your user’s manual to determine if your model and software has etching capabilities.
Can glass be cut on a waterjet?
Yes, glass can be cut on a waterjet. Depending on the thickness, glass may flex during cutting and therefore should be fully supported on a flat level surface. HYDROBLOC waterjet bricks are a good support and will reduce the chance of frosting on the bottom of the glass. Read more
How do I remove spent garnet from my waterjet tank?
The BARTON Abrasive Removal Tool (BART) is a convenient and effective tool for removing spent garnet from your waterjet tank. BART complements any type of central abrasive removal system. BART can clean many areas of the waterjet tank that the central removal systems don’t Read more
How do I calculate how much garnet I will need for my application?
Total garnet required for any waterjet cutting application is calculated by the OEM software. Orifice/nozzle configuration will determine the recommended abrasive flow rate per minute. Once abrasive flow is determined, flow rate can be multiplied by the total inches per minute Read more
Four Reasons Why Garnet Is the Best Waterjet Abrasive
Garnet has been the preferred choice for waterjet cutting for decades because of its proven ability to cut faster; produce cleaner, more precise edges; and do so on the widest possible variety of materials.
Four inherent physical characteristics of garnet make all the Read more
If you’re still paying to have used garnet abrasive pumped from your waterjet table, or worse yet, shoveling it out yourself, we encourage you to get to know