Waterjet Cutting

Any changes of waterjet grades or abrasives from different suppliers will require recalibration of the abrasive flow rate. Because particle size distributions (PSD) vary from supplier to supplier abrasive will flow at different rates. Once the abrasive flow rate has been calculated, the measured feed rate must be entered into the OEM software. Learn Read more

Total garnet required for any waterjet cutting application is calculated by the OEM software. Orifice / nozzle configuration will determine the recommended abrasive flow rate per minute. Once abrasive flow is determined, flow rate can be multiplied by the total inches per minute to determine the required volume of garnet. The OEM software may produce Read more

The BARTON Abrasive Removal Tool (BART) is a convenient and effective tool for removing spent garnet from your waterjet tank. BART complements any type of central abrasive removal system. BART can clean many areas of the waterjet tank that the central removal systems don’t effectively clean, and BART produces higher removal rates on an hourly Read more

HPX is a hard rock garnet abrasive with an Adirondack advantage — the sharpest, hardest garnet crystals on Earth with a unique crystalline structure and durability. Named for the Adirondack Mountains where it is exclusively mined by BARTON, ADIRONDACK HPX is the sharpest, cleanest, fastest cutting and most precise waterjet cutting abrasive available. Read more

Yes, glass can be cut on a waterjet. Depending on the thickness, glass may flex during cutting and therefore should be fully supported on a flat level surface. HYDROBLOC waterjet bricks are a good support and will reduce the chance of frosting on the bottom of the glass. We Read more

BARTON garnet abrasives can be used to etch using a waterjet. However not all waterjet equipment has the software required for etching. Check your users manual to determine if your model and software has etching capabilities.

While BARTON has strong, supportive relationships with virtually every OEM, we do not recommend one waterjet machine supplier over another. We can assist you in making sure that you are aware of all of the OEMs and discuss what machine types they may offer.

The primary factors on kerf loss are nozzle diameter and orifice selection. Using a larger nozzle than needed will increase kerf loss. Orifice alignment will also affect kerf loss. Improper orifice alignment will cause the stream to bounce inside the nozzle and will decrease nozzle life and lead to additional kerf loss. If common line Read more

Yes BARTON offers a garnet recycling program, however there are some local and regional restrictions that limit the areas the program is available. Contact your regional sales manager to learn more.